Clip on's again

[mikesbytes]

T7 have $50 clip on's.

http://www.torpedo7.com.au/products/T7HBAN9TC

From the picture, it looks like they would fit on the Focus, as the clamping is right beside stem.

A little concerned about my bars being carbon though.

[weiyun]

Follow the torque spec and you should be right. But it'd be worth double checking the clamp surface and smooth it up as needed. Then a layer of assembly compound should complete the deed.

[Toff]

Mike, have you finished with my Velocity bars?

[mikesbytes]

Follow the torque spec and you should be right. But it'd be worth double checking the clamp surface and smooth it up as needed. Then a layer of assembly compound should complete the deed.

Yes, I need to be careful with clamping them to carbon bars. Depending on how it actually clamps on, I might also need to put a thin layer of rubber or the like. Shall see when/if I get them

Mike, have you finished with my Velocity bars?

Yes, technically the Velocity Bars are illegal, as there is a maximum reach and the joining loop makes them longer.

If you don't want them back, I'll throw them in, when I auction off your skin suit