Dulwich Hill Bicycle Club

T7 have $50 clip on's.

http://www.torpedo7.com.au/products/T7HBAN9TC

From the picture, it looks like they would fit on the Focus, as the clamping is right beside stem.

A little concerned about my bars being carbon though.

Follow the torque spec and you should be right. But it'd be worth double checking the clamp surface and smooth it up as needed. Then a layer of assembly compound should complete the deed.

Mike, have you finished with my Velocity bars?

Follow the torque spec and you should be right. But it'd be worth double checking the clamp surface and smooth it up as needed. Then a layer of assembly compound should complete the deed.

Yes, I need to be careful with clamping them to carbon bars. Depending on how it actually clamps on, I might also need to put a thin layer of rubber or the like. Shall see when/if I get them

Mike, have you finished with my Velocity bars?

Yes, technically the Velocity Bars are illegal, as there is a maximum reach and the joining loop makes them longer.

If you don't want them back, I'll throw them in, when I auction off your skin suit